Field note 10 · Cars and boats
Laying up a boat for winter
Haul-out, engine, water systems and the shrink-wrap. What a marina does at the end of the season, and what to check before you sign off.
In a cold climate, a boat left in the water or put away wet is one hard frost away from a cracked engine block. Winterising, or laying up, is the routine that prevents that. Most owners hand the whole job to their marina, which is sensible, but it still pays to know what should be done, so you can see that it was.
Book the haul-out early
Marinas run on a schedule at the end of the season, and the slots fill quickly once the first cold nights arrive. Book the haul-out date in late summer. If the boat is going to indoor storage, book that space at the same time.
Check your policy at the same time. Many boat insurance policies in Canada and the northern US set a navigation period and a lay-up period, and the boat is expected to be out of the water during lay-up. Being in the water after that date can affect a claim.
Out of the water
After the haul-out, the hull is usually pressure-washed before the growth dries on. It's the best moment to look at what you can't see all summer.
- The hull below the waterline: blisters, cracks, damage to the gelcoat.
- Sacrificial anodes (zincs): replace any that are worn down.
- Propeller and shaft: dings, fishing line wrapped round the shaft, play in the bearings.
- Rudder and through-hull fittings.
Ask the marina to send photos of anything they find. It's much easier to agree spring repairs in November than in May, when everyone wants their boat at once.
The engine
Engine winterising varies with the type of engine and the maker's instructions, but usually includes:
- Changing the engine oil and filter, so acidic used oil doesn't sit in the engine all winter.
- Changing the gear oil in outboards and sterndrives, and checking it for water, which can point to a failing seal.
- Filling the fuel tank and adding stabiliser, then running the engine so treated fuel reaches it.
- Flushing the raw-water cooling system and filling it with non-toxic antifreeze, or draining it fully, depending on the engine.
- Fogging the cylinders on many petrol engines to protect them from corrosion.
- Checking belts, hoses and impellers, and replacing any that are near the end of their life.
Water systems and plumbing
Anything on board that holds water can freeze and split: freshwater tanks and lines, the water heater, sinks, showers, heads and holding tanks. These are drained and filled with non-toxic potable antifreeze following the boat's systems. Air conditioning systems that use seawater need the same treatment.
Inside the boat
Take off everything that can be damaged by damp or tempts a thief: electronics that unclip, cushions, life jackets, flares, food and drinks. Prop open lockers, fridges and hatches inside the cabin to let air move. Moisture absorbers help. Batteries are either removed and kept charged, or left on board with a maintainer if the boat has shore power in storage.
Cover and check
Outdoor boats are usually shrink-wrapped. A good wrap is tight, has vents so moisture can escape, and has a zip door so someone can get on board for checks. A poor one sags, collects water and snow, and traps condensation against the boat.
A stored boat still needs the occasional visit. After heavy snow or a big storm, someone should check that the wrap or cover is intact and that nothing has shifted on the cradle. Ask your marina whether checks are included in storage, and how they'll tell you if something is wrong.